Fujifilm 15695991 Datasheet download pdf (Page 2)

FUJIFILM DATA SHEET ¥ FUJICOLOR SUPERIA 200

Daylight

Even when exposed under morning or evening twilight

conditions or when color temperatures are low, no

special filter use is needed color balancing will be done

during printing.

Electronic Flash

¥ Electronic flash produces light similar to daylight,

so filters are not needed. However, the possibility

of undesirable effects on color balance, due to

various factors (differences in equipment, amount

of use, etc.) should be taken into consideration

and test exposure made.

¥ If shutter speeds slower than 1/60 second are

used, light from non-flash sources, such as room

lighting, may cause color imbalances. Make test

exposures.

¥ The use of a flash meter is advisable, but the fol-

lowing formula can also be used to obtain satisfac-

tory lens opening.

¥ Set the film speed at ISO 200. Since the amount

of light reflected onto subjects from surrounding

surfaces will differ with the conditions, refer to the

flash unit instructions.

Daylight Photoflood/Photo-Reflector Lamps

¥ Daylight-type photoflood or photo-reflector lamp

output tends to be lower than that indicated by an

exposure meter, so it is advisable to compensate

for this by increasing exposure time or the lens

opening. Whenever possible, test exposures are

recommended.

¥ Other factors requiring consideration when deter-

mining the exposure time, are lamp configuration,

use duration and line voltage, as they may affect

lamp output and color balance.

Fluorescent Lamps & High-Intensity Discharge

Lamps

¥ For best results, the following combinations of

color compensating filters are recommended.

However, for exacting work, test exposures are

advisable.

Lens

Aperture

(f-number)

ISO 200 Electronic Flash Guide Number

Electronic Flash-to-Subject Distance

(meters or feet)

* Fuji Color Compensating Filters (or Kodack CC Filters)

** Exposure Correction values include filter exposure factors.

These values are added to unfiltered exposure meter read-

ings. "+" followed by number = required increase in lens

opening.

¥ When the fluorescent lamp characteristics are un-

known, to obtain generally acceptable results, use

a 30M compensating filter and open the lens one

stop (+1).

NOTE Different compensation may be required accord-

ing to special lamp types and length of use, so test

exposures are recommended, whenever possible.

¥ Shutter speeds of 1/125 second for high-intensity

discharge lamps and 1/30 second or larger, for

fluorescent lamps, will avoid AC power-induced

changes in brightness and color being recorded on

the film.

Tungsten Lamps

Fuji Light Balancing Filter LBB-12 (or Kodak No. 80A) is

recommended along with a 2 lens stop increase, when

using 3200 K tungsten lighting.

5. LIGHTING EQUIPMENT

The conditions of umbrellas, reflectors, diffusers and

like devices, may influence photographic light quality.

Periodically check lighting equipment for deterioration.

6. LONG EXPOSURE COMPENSATION

No exposure or color balance compensation is required

for exposures within a 1/4000 to 2 second shutter

speed range. However, for exposures of 4 seconds or

longer, provide the compensations indicated below.

* "+" followed by number = required increase in lens opening.

Except for special effects, the normal intensity ratio for

main-to-fill subject lighting should remain within 1:4

limits.

White

(W)

10C

+1/3

Day-

light

(D)

10M

+10Y

+1/3

Cool

White

(CW)

—

Warm

White

(W.W)

30C

+30M

Deluxe

White

Mercury

+10C

+1/3

Clear

Mer-

cury

40M

+40Y

+1 1/3

Lamp Type

Color

Compensat-

ing Filters*

Exposure

Corrections**

Fluorescent

High-intensity

Discharge

Exposure Time (sec)

Exposure Corrections*

1/4000 - 2 4 16 64

Unnecessary +1/3 +2/3 +1

1 2 3 4

Comments to this Manuals

No comments

Fujifilm 15695991 Datasheet Page 2

Comments to this Manuals

Related products and manuals for Colour films Fujifilm 15695991